Haeg.in

A short while ago I was having some problems with certain housemates deciding to unplug my server (which I use for IRC, general tasks, file sharing, remote access and torrenting) from the network. This began to get slightly annoying as I was often using the server remotely at the time so I grabbed an old wireless USB stick I had lying around and set up bonding using my wired ethernet as the main connection and the wireless as the fallback.

It took a while to get the configuration right as the various guides on the Internet all seem to be aimed at bonding two wired devices together for extra speed (a nice idea but gigabit is plenty fast enough and when I was trying this I didn't have a spare gigabit interface on both my desktop and my server). In the end I got it working with the configuration below. The wireless key has been changed for security reasons.

# Bring up lo and bond0 on boot
auto lo bond0

# The loopback interface
iface lo inet loopback

iface bond0 inet dhcp
    bond_mode       active-backup
    bond_primary    eth0
    bond_miimon     100
    bond_downdelay  200
    bond_updelay    200
    slaves          eth0 wlan0
# You only need the lines below if you don't use DHCP
#   netmask         255.255.255.0
#   address         192.168.1.100
#   network         192.168.1.0
#   gateway         192.168.1.1
#   broadcast       192.168.1.255
    wpa-driver      wext
    wpa-ssid        "my-wireless-network-name"
    wpa-iface       wlan0
    wpa-key-mgmt    WPA-PSK
    wpa-psk         "my-wireless-network-password"

This brings up the bond0 interface on startup which starts the eth0 and wlan0 interfaces. The bond_ entries control the bonding. "bond_mode" ensures we use the primary interface where possible and fall back to the slave when it isn't available. "bond_primary" sets eth0 as the primary interface leaving wlan0 as the slave. bond_miimon seems to be set to 100 in every guide I found and is apparently the MII monitor time interval, whatever that is. bond_downdelay sets how long to wait after a host is found to be down before confirming it is down and switching to a fallback host. bond_updelay works similarly when an interface comes back up. This stops a flakey network connection causing so many problems. All these time settings are measured in milliseconds.